Mechanical Gas Fuel System G5.9, G8.3, G855 – Master Repair Manual 019-105   Ignition Control Module

Preparatory Steps

TOC

 WARNING 

Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
  • Disconnect the battery cables and connections. Refer to the OEM service manual.
  • Disconnect the air/fuel supply to the air starter, if equipped. Reference Procedure 012-022 in Section 12 of the service manual of the engine being serviced.

SMALL | MEDIUM | LARGE

Remove

TOC

Disconnect the two ignition control module connectors.

SMALL | MEDIUM | LARGE
   


Remove the four ignition control module mounting capscrews.

Remove the ignition control module.

SMALL | MEDIUM | LARGE
   

Install

TOC

Be sure the bracket surfaces around the bottom two control module mounting holes (1) are bare metal and free from paint, debris, and corrosion.

Position the ignition control module onto the bracket and align the holes.

Install the four mounting capscrews and tighten.

Torque Value:  24  n.m  [212 in-lb]

SMALL | MEDIUM | LARGE
   


Connect the two ignition control module connectors.

SMALL | MEDIUM | LARGE
   

Finishing Steps

TOC

 WARNING 

Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
  • Connect the air/fuel supply to the air starter if equipped. Reference Procedure 012-022 in Section 12 of the service manual of the engine being serviced.
  • Connect the battery cables and connections. Refer to the OEM service manual.
  • Operate the engine and check for proper operation.

SMALL | MEDIUM | LARGE
Last Modified:  08-Dec-2009